 |   
| | |  Codes/Ordinances
New Pattonsburg, Missouri Solar Codes & Ordinances
Summer 1996
ARTICLE XIV
SPECIAL PROVISIONS
14-101 Purpose: Special provisions are set forth in this article
which deals specifically with unusual or extraordinary circumstances which
may, from time to time, come before the municipal planning commission.
The special provisions of this article will provide a means by which unusual
requests, of a nature specified herein, may be considered and acted upon.
14-102 Subdivision Provisions; Land Suitability: No land shall
be subdivided within the City of Pattonsburg if the parcel or parcels of
land proposed for development are deemed unsuitable for a proposed use
because of flooding potential, inadequate water supply or sewage disposal
facilities, known mining subsidence areas from past mining activities,
or any other conditions likely to be harmful to the health, safety or welfare
of future residents of the proposed subdivision or of the community.
14-103 Mineral Exploration and Commercial Mining: Within the
corporate limit of the City of Pattonsburg, regardless of zone district,
all commercial-scale mineral exploration and mining activities shall be
subject to the granting of a conditional use permit prior to the commencing
of such work. The permit shall specify the nature of the proposed work,
its duration, and the safeguards to be employed in protecting the general
public from any excavations left as a result of mineral exploration or
commercial mining.
14-104 Solar Access Provision: The use of solar energy collectors
for the purpose of providing energy for heating and/or cooling is a permitted
use within all zone districts, whether as a part of a structure or incidental
to a group of structures in the nearby vicinity. Use of solar energy collectors
is subject to the restraints imposed by the present development pattern
and topography found inside the city limits of Pattonsburg plus the zoning,
height, and where a strict provision of the zoning ordinance may prohibit
adequate solar access, the developer may apply for a conditional use permit
from the city by filing said application with the planning commission.
The Planning Commission shall weigh the following factors in its evaluation:
(A) Different levels of solar access available and restrictiveness
of ordinance with regard to height, bulk, setback, and related provisions.
(B) Local energy costs, topography, and aesthetics of the specific
area or land tract proposed for solar access use.
(C) Characteristics of shading due to building and trees in determination
of necessary solar access plane.
(D) Identification of possible conflicts with solar access, including
architectural or historic preservation requirements, steep slopes, low
and moderate income housing restrictions, and individual landowner preferences.
14-105 Solar Access Requirements: When a solar energy collection
system is installed on a lot, accessory structures or vegetation on an
abutting lot shall not be located so as to block the solar collectors access
to solar energy. The portion of a solar collector that is protected is
the portion which:
(A) Is located so as not to be shaded between the hours
of 10:00 a.m. and 3:00 p.m. by a hypothetical 12-foot obstruction located
on the lot line; and,
(B) Has an area not greater than one-half of the heated floor
area of the structure, or the largest of the structures, to be served.
14-106 Solar Access Exemptions: Section 10-104 (above) does not
apply to structures or vegetation existing in an abutting lot at the time
of installation of the solar energy collection system, or the effective
date of this ordinance, whichever is later. Said subjection controls any
structure erected on, or vegetation planted in, abutting lots after the
installation of the solar energy collection system.
14-107 Solar Energy System Installed; Recording Procedures: A
statement that a solar energy collection system is installed in a lot shall
be filed and recorded with the Zoning Administrator or City Clerk, and
that the date of installation of said system shall be the date of recordation.
14-108 Unconventional and Earth Sheltered Housing Encouraged: It
is recognized that innovative housing designs appear from time to time
that encourage energy conservation, create welcome diversity in the community,
and which will appeal to home builders and buyers. It is the intent of
this ordinance, through the provisions of the Special Use Permit and variance
procedures contained herein, to recognize and encourage creative, efficient,
and well-designed housing of innovative varieties. Each sheltered housing
as one example of newer trends in housing construction, shall generally
adhere to the following provisions, based on the issuance by the Board
of Aldermen of a Conditional Use Permit and granting of any applicable
variances from the strict design provisions of the ordinance.
(A) Densities or lot areas and lot widths for earth
sheltered housing units shall conform to those established residential
zone districts R-1 and R-2.
(B) Earth sheltered housing units may be attached, semi-detached
or attached, and shall be permitted in residential districts only.
(C) Each room of primary living area shall be provided with exterior
windows, subject to the following conditions:
(1) No window facing or within 45 degrees parallel to
a side or rear property line shall be constructed within 20 feet of that
line.
(2) No window facing the front property line shall be built within
the normally established front yard setback area, except for kitchens and
utility areas, which may be located within not less than one-half of the
established set-back distance.
(3) Every living room or bedroom shall have a glassed area of
not less than 10 percent of the floor area, and give direct visual access
to natural light and open space.
(D) An outdoor space of not less than 500 square feet shall be provided
immediately outside of the walls of the dwelling subject to the following
conditions:
(1) The average grade of elevation of this space shall
be no more than two feet apart from the floor level of surrounding rooms,
or of the rooms having access to it.
(2) The minimum horizontal dimensions of the outdoor area shall
not be less than 20 feet.
(3) The average height of the walls surrounding this space shall
not exceed 10 feet.
(4) Where floor area of an earth sheltered dwelling is less than
1,500 square feet, minimum outdoor area may be reduced to 300 square feet,
with a minimum outdoor dimension of 15 feet.
(5) Granting of a conditional use permit and any appropriate
variances shall be contingent upon planning commission review of a suitable
building plan, and general sketch indicating lot orientation and related
requirements.
14-109 Wind Energy Conversion Systems: This section provides basic
design criteria intended to encourage the responsible use of wind energy
conversion systems (WECS) consistent with the public safety. These devices
shall be defined as any system intended or constructed for the purpose
of converting wind power to energy, regardless of whether or not the system
is experimental or a commercial operation. These devices include windmills,
wind power turbines, and wind chargers.
(A) Conditional Use Permit Required for WECS.
Installation of a WECS is subject to review by the City Planning Commission,
pursuant to sections 201 and 210 of the Public Utilities Regulatory Act
of 1978, or laws amendatory thereto. Installation of a WECS within the
City of Pattonsburg is subject to the granting of a conditional use permit.
(B) Design criteria for WECS.
(1) Height: The height of any WECS tower shall not exceed
the height requirement or ceiling for the zone district within which the
location of the tower is proposed.
(2) Setback: The WECS tower shall be setback 1.5 times the height
of the tower in all zone districts.
(3) Fencing: A six (6) foot fence with a locking portal
is required around any WECS tower to prevent potential climbing hazards.
(4) Braking Device: All WECS devices shall have braking
systems when winds reach speeds in excess of 40 miles per hour.
(5) Guidelines: All WECS towers shall have appropriate stabilizing
guidelines.
EXHIBIT E
ENERGY STANDARDS
View Table
Notes:
General
R-19 in crawlspace underside of floor and rim joist area
Vapor retards over bare soil for slab-on grade and for crawl space
Air DuctsR-7 on supply and return air ducts in unconditioned space
Water Pipesinsulate hot and cold water pipes in conditioned space
for minimum of first 6 feet
Minimum .50 CFM exhaust fans in bathrooms
Minimum 100 CFM exhaust fans in kitchen
Automatic setback thermostats for gas heat
Seal all duct joints (supply and return) with duct mastic such as
RCD #6, Hardcast or Aqua-Fas
Windows
Double glazed windows with low-E coating
Solid core insulated doors
Caulk, weatherstrip and seal around window and doorframes
Minimize doors and windows on the north wall
Air Sealing
Air barrier house wrap, caulk and seal at top and bottom edges and
seams
Seal all penetrations through thermal building envelope (such as
electrical, plumbing and vent penetrations or chimneys with caulk or foam
Seal drywall to framing members or exterior walls and ceiling or
use a "vapor barrier" on all walls and ceiling between conditioned and
unconditioned space
Airtight electrical boxes on exterior walls
Install sill sealer under sillplate
Caulk sole plate and top and bottom edge of rim joist
Average air change .35 to . 5 per hour, but not less than 15 cfm
per person
II. Standards for Small Commercial Buildings (60' x 160')
A. Lighting:
| Total interior lighting connected load |
1 W/ft2 |
| Controls: |
| Switching |
450 ft2/switch |
| Motion sensor (office) |
50% of office area |
| Exterior Lighting |
|
| Lighting Type load (KW): |
|
| Fluorescent |
.088 |
| Incandescent |
.224 |
| HID |
1.047 |
| |
1.36 |
Schedule (except for security lights) sunset - midnight
B. Auxiliary Systems and Equipment
| Office Equipment Power Density |
.47 W/ft2 |
| Refrigeration Equipment Electric Load |
.06 W/ft2 |
| Cooking Equipment |
|
| Electric Load |
.035 W/ft2 |
| Gas |
.059 Btu/h/ft2 |
C. Building Envelope
| Exterior Wall Construction |
|
| Ceiling height |
9 ft. |
| U-value (R-value) |
.08 |
| Window to wall ratio |
17% (on each wall) |
| Window U-value (including frame) |
.41 |
| Shading Coefficient |
.46 |
| Roof Construction |
|
| Type |
bar jst/mtl deck |
| Slope |
"flat" |
| U-value (R-value) |
.05 |
| Absorption |
.65 |
| Overhang |
.5 |
| Floor Construction |
|
| Type |
grade |
| U-value (R-value) |
U-value (R-value) |
D. HVAC Systems
| System sizing |
|
| CFM/ft2 |
1.20 |
| CFM/ft2 fresh air |
.14 |
| Fan W/cfm |
.27 |
| System setpoints |
|
| Heating |
72°F |
| Heating (unoccupied hours) |
55°F |
| Cooling |
75°F |
| 75°F |
Off |
| System type: |
roof top, all air, 1 unit/tenant up to 5 tenants |
| Heating System |
|
Gas furnace efficiency
(< 225,000 Btu/h AFUE) |
.81 |
< =65,000 Btu/h
(split system/single package |
8.0/7.8 |
>65,000, < =135,000Btu/h
(steady state COP) |
3.4 |
| Cooling System Efficiency |
|
< = 65,000 Btu/h
(SEER-seasonal value) |
12 (10.8 EER) |
| Ventilation & Infiltration |
|
| cfm/person |
20 |
| ft2/person |
143 |
| Infiltration, cfm/ft2 of gross wall |
.038 |
E. Domestic Hot Water
| Type |
|
| Electric resistance (EF) |
.88 |
| Gas (EF) |
.54 |
| Load gas/person/day |
1 |
| Pipe length |
25 ft. |
| Pipe insulation |
none |
| Circulating pump |
no |
F. Energy Management Systems
Zone control
Heat pump supplemental heat control
Automatic shutdown controls
Zone isolation
Economizer controls
III. Site Planning Requirements for All Buildings
A. All buildings (other than zero lot line) and landscaping
must be designed and located so as not to interfere with the reasonable
use of adjoining properties for solar applications. Evergreens should not
be planted closer than twenty feet (20') from side lot lines adjoining
a building lot.
B. All residential lots must have trees planted to maximize summer
cooling.
IV. Recommended Procedures
A. Citizens should use energy efficient equipment wherever
reasonably practical, including energy efficient motors, processes, lighting,
and daylighting, passive solar, solar water heaters, geothermal, biomass,
load management, photovoltaics, district heating and cogeneration.
B. Citizens should use and participate in state and federal energy
programs including Green Lights, Nice3 KP, Exemplary Buildings,
Motor Challenge, PT1 Green Buildings, Rebuild America, SECP, Energy Star
Buildings, SBA Pollution Control Loans, SBA EERE Loans and ISTEA Enhancement
Funds as well as such other similar programs as may exist from time to
time.
C. Citizens should orient both new construction and relocated
buildings to maximize the solar benefits that they or future generations
may obtain.
D. In relocating existing residences to and placing manufactured
homes in New Pattonsburg, citizens should: (i) have an energy audit and
analysis conducted to identify practical energy conservation measures,
(ii) replace heating and cooling equipment and appliances with energy efficient
devices, (iii) construct on foundations designed to increase energy efficiency
and (iv) weatherize the dwellings.
E. In constructing new homes in New Pattonsburg, citizens should
(i) make maximum use of daylighting, (ii) use roof colors that decrease
cooling needs, (iii) landscape to maximize solar and wind benefits and
(iv) use energy efficient lighting throughout the house.
F. Citizens should use vines and trellises to shade outdoor cooling
units and the southern exposure of buildings.
Back to Top
HOME
| SEARCH
|